1. The red light flashes after power on, but the blue light does not flash
A. Please press and hold the reset button for about 3 seconds, you will hear a beep and the following voice prompt "System Reset", the camera will reset, and the blue light will flash.
B. If the customer presses the reset button for 8 seconds, the camera will enter the AP mode, and the Ubox-*** hotspot will be issued. At this time, the camera will flash red. Note that in the AP mode, the camera network cannot be configured, the customer only needs to press 3 again The second reset button can be reset.
2. How to watch the camera directly in AP mode
Connect the mobile phone to the camera AP hotspot, the AP hotspot password is 12345678, then log out of the APP account and log in to the APP to directly enter the monitoring screen.
3. Remove 5GHz wifi off your modem and phone